iPhone6 mobile phone battery replacement method

iPhone6 mobile phone battery replacement method

Prepare the tools you need to use: 1. Two types of screwdrivers 2. Suction cup 3. Sputum 4. Ramps 5. Double-sided adhesive, you can choose to buy from Amazon. All the tools in the box are already installed.

1. Use a yellow handle screwdriver inside the box to unscrew the two red screws that are marked in the figure.

2. Use the suction cup to suck in the lower part of the display and pull up until there is a gap

3. Use the suction cup to suck down on the display and pull up until a gap appears below

4. Use a suction cup to suck in the lower part of the display, pull it up, and suck a gap below

5. Use a cymbal to pick up the screen slowly. Of course, you can use your fingernails if you are confident with your nails.

6. Do not exceed 90 degrees after opening. Otherwise, it is easy to damage the phone

7. Use the blue screwdriver in the battery box to unscrew the seven red screws in turn and remember the position of the screws. I stick the screws to the wide tape according to the position shown in the figure below.

8. Remove the screen, and remove the screws and washers. Note that the screws are glued to the tape by position!

9. Use a hair dryer to blow the heat on the back cover of the phone. Be sure to have patience. The ultra-thin double-sided adhesive under the battery is very good and it is not easy to remove. Take out the battery slowly using a cymbal, and the original battery It’s a bit soft, it doesn’t matter if it’s deformed. The image above is what it looks like after it’s removed.

10. The battery is installed, the cable is plugged in, because the cable socket is relatively fine, slowly press gently, then put the gasket on, screw the screw, the screen of the four rows of plug-in turn, washer screw as above, The screen is buckled and Screw in the screw under the phone

After the new iPhone battery is changed, start up.